brute force neutral plate cell Project Page 1

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: January 11, 2009 10:50pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from resident_genius

Click Here to Re-Display the Main Project Page

this was the original setup, having a two bolt deal. i found that the manufacturing process (stamping) had left tiny imperfections that left the cell spacing imperfect...

...as can be seen easily in this photo...

...so i went with a quad bolt setup. the holes were drilled through the entire stack at once, and the resulting burrs were sanded smooth. ...

....cell stack partially assembled.....